Facing the house has a beneficial effect on the walls, protecting them from moisture and frost, but also improves the appearance of the building. Typically, for a given

Procedure uses a special decorative brick, which has a smaller thickness and a better appearance than normal

The building.

Experts recommend using 50 – 55 units of material per square meter. When planning this event, you must

Provide an additional tab of the basement and plinth as coating is a special enclosures having

A certain weight. In most cases the reason for the stone wall are made of red brick and lay on the floor level.

When marking the foundation takes into account such factors as the thickness of lining, ground lug, and the indentation of the wall cladding to the wizard. As

Typically, the thickness of the decorative brickwork is 12 cm, whereas the distance between the wall and cladding shall be not less than 2 cm Consequently, the

Width of the foundation should be about 25 – 30 cm depth of bookmarks should be calculated, starting from the indicators of degree of soil freezing in winter.

Today’s manufacturers offer two types of material: single brick for lining and one and a half. And he and the other is good for the job. Before

Start laying, experts advise expand the first row of dry material, taking into account the doors and windows. When facing the house in

Removal half-brick exterior wall shall not exceed 10 cm Where he is 6 cm, and a decorative design to attach to the wall

Special nails 100 mm long.

If the building is used for decorating silicate brick, the length of the removal should not exceed 6 cm should also be remembered that this kind of stuff

Ill pass moisture, and therefore it is desirable to use for laying rigid solutions with low water content. Additionally, you can pave

Special insulating lining cloth, which does not give a solution to clean up the seams in the rain.

The thickness of the seam in the masonry cement shall not exceed 13 mm. Monitor this indicator should be a special rail-poryadovkoy. If the brick

Has a thickness of 65 mm, the normal rate is 77 – 78 mm rail. After every fifth series of bricks tested height of the lighthouse. This is done

Using the same rail-poryadovki. Standard – 385 – 390 mm.